1	Chapter 19 Methods of AC Analysis
2	Dependent Sources Voltages and currents of independent sources Not dependent upon any voltage or current elsewhere in the circuit In some circuits Operation of certain devices replaces device with an equivalent model
3	Dependent Sources Models are dependent upon an internal voltage or current elsewhere in the circuit
4	Dependent Sources Have a magnitude and phase angle determined by voltage or current at some other circuit element multiplied by a constant k Magnitude of k is determined by parameters within particular model
5	Dependent Sources Units of constant correspond to required quantities in the equation
6	Source Conversion A voltage source E in series with an impedance Z Equivalent to a current source I having the same impedance Z in parallel I = E/Z E = IZ
7	Source Conversion Voltages and currents at terminals will be the same Internal voltages and currents will differ
8	Source Conversion A dependent source may be converted by the same method Controlling element external to circuit If controlling element is in the same circuit as the dependent source Procedure cannot be used
9	Mesh Analysis Method exactly the same as for dc Convert all sinusoidal expressions into phasor notation Convert current sources to voltage sources Redraw circuit, simplifying the given impedances
10	Mesh Analysis Assign clockwise loop currents to each interior closed loop Show polarities of all impedances
11	Mesh Analysis Apply KVL to each loop and write resulting equations Voltages that are voltage rises in the direction of the assumed current are positive Voltages that drop are negative
12	Mesh Analysis Solve the resulting simultaneous linear equations or matrix equations
13	Nodal Analysis Method is exactly the same as for dc Nodal analysis will calculate all nodal voltages with respect to ground Convert all sinusoidal expressions into equivalent phasor notation
14	Nodal Analysis Convert all voltage sources to current sources Redraw the circuit Simplifying given impedances and expressing impedances as admittances
15	Nodal Analysis Assign subscripted voltages to nodes Select an appropriate reference node Assign assumed current directions through all branches Apply KCL to each node Solve resulting equations for node voltages
16	Delta-to-Wye Conversion Impedance in any arm of a Y circuit Determined by taking the product of two adjacent D impedances at this arm Divide by the summation of the D impedances
17	Delta-to-Wye Conversion
18	Wye-to-Delta Conversions Any impedance in a D Determined by summing all possible two-impedance product combinations of the Y Divide by impedance found in opposite branch of the Y
19	Wye-to-Delta Conversions
20	Bridge Networks Bridge circuits are used to measure the values of unknown components Any bridge circuit is balanced when the current through branch between two arms is zero
21	Bridge Networks The condition of a balanced bridge occurs when
22	Bridge Networks When a balanced bridge occurs in a circuit Equivalent impedance of bridge is found by removing central Z and replacing it by a short or open circuit Resulting Z is then found by solving series-parallel circuit
23	Bridge Networks For an unbalanced bridge Z can be determined by D-to-Y conversion or mesh analysis
24	Maxwell Bridge Used to determine the L and R of an inductor having a large series resistance L = R₂R₃C R = R₂R₃/R₁
25	Maxwell Bridge
26	Hay Bridge Used to measure the L and R of an inductor having a small series resistance
27	Hay Bridge
28	Schering Bridge Used to determine an unknown capacitance